Wolf RM-2 - Program Selection; Time Program Flowchart (Controller Function Only); Time Program Type Selection (HTG, DHW, Ventilation)

Appendix
52 | WOLF GmbH 3066510_202108
10.4.2 Program selection
5@ Program selection - controller - ventilation. Use the + and - keys
to switch between program selections. The selected value will
ash. Use the tick key to conrm the program selection or the
Back key to discard your changes.
10.5 Time program owchart (controller function only)
10.5.1 Time program type selection (HTG, DHW, ventilation)
4# Time program type selection. Use the arrows to cycle between
heating, DHW and ventilation. Your current selection will ash.
Use the tick key to conrm the time program type or the Back key
to discard the change.