Wolf RM-2 - Page 40

Appendix
40 | WOLF GmbH 3066510_202108
qStartup screen. Displayed if you turn on the RM-2 with no SD card
installed or if there is no RM-2 rmware (FW) on the SD card. All
symbols will be displayed for 2 seconds
7) Update the RM-2. Displayed if the FW on the SD card is newer
than the RM-2 FW. The current FW version will be displayed on
the top. The new FW version will be displayed on the bottom.
Press the tick key to apply the update or the cancel key to skip it.
7! Perform update. A moving rectangle will be displayed while the
update is underway.
7@ Forget SD card. If the unit detects that the version of the FW on
the SD card is earlier than the FW of the RM-2 after a restart,
“Sd” will be displayed for 5 seconds. Use the tick key to skip this
screen.