5-S8
L3130 · L3430 · L3830 · L4630 · L5030, WSM
BRAKES
Rear Wheel and ROPS (ROPS Model)
1. Place the disassembling stand under the transmission case.
2. Remove the rear wheel mounting screws and nuts.
3. Remove the rear wheels.
4. Remove the top link (2) and lift rod (4).
5. Disconnect the check chain (6) and remove the lower link (5).
6. Remove the ROPS lower frame mounting screws (7), (8).
7. Dismount the ROPS assembly (1), (3).
(When reassembling)
W10149730
Rear Wheel and Cabin Mount Screw (Cabin Model)
1. Place the disassembling stand under the transmission case.
2. Remove the rear wheel mounting screws and nuts.
3. Remove the rear wheels.
4. Remove the top link (1) and lift rod (2).
5. Disconnect the check chain (4) and remove the lower link (3).
6. Place a block of wood (5) between cabin and lift arm (6) to
support the cabin.
7. Remove the cabin mount bracket mounting bolt (8) and nut.
(When reassembling)
• Be sure to install the washers, plate and mount rubbers, etc. in
their original positions.
W1015212
Tightening torque
Rear wheel mounting
screw and nut
215 N·m
22 kgf·m
160 ft-lbs
Rear wheel mounting stud
bolt
98.1 to 112.8 N·m
10.0 to 11.5 kgf·m
72.3 to 83.2 ft-lbs
ROPS lower frame
mounting screw
166.7 to 196.1 N·m
17 to 20 kgf·m
123 to 144 ft-lbs
(1) ROPS Upper Frame
(2) Top Link
(3) ROPS Lower Frame
(4) Lift Rod
(5) Lower Link
(6) Check Chain
(7) Screw (M14 × 155)
(8) Screw (M14 × 30)
A : L3130, L3430
B : L3830, L4630
Tightening torque
Rear wheel mounting
screw and nut
215 N·m
22 kgf·m
160 ft-lbs
Rear wheel mounting stud
bolt
98.1 to 112.8 N·m
10.0 to 11.5 kgf·m
72.3 to 83.2 ft-lbs
Cabin mounting bolt and
nut
124 to 147 N·m
13.0 to 15.0 kgf·m
91.0 to 108.0 ft-lbs
Cabin mount bracket
mounting screw
166.7 to 196.1 N·m
17 to 20 kgf·m
123 to 144 ft-lbs
(1) Top Link
(2) Lift Rod
(3) Lower Link
(4) Check Chain
(5) Block of Wood
(6) Lift Arm
(7) Cabin Mount Bracket
(8) Bolt (M14 × 90)
(9) Spring Washer
(10) Plain Washer
(11) Plate
(12) Mount Rubber
(13) Collar
(14) Nut
To Next Page
