5-S9
L3130 · L3430 · L3830 · L4630 · L5030, WSM
BRAKES
Rear Axle Case
1. Disconnect the brake rod.
2. Disconnect the parking brake rod and parking brake cable (left
side only).
3. Place the disassembling stand under the rear axle case.
4. Remove the rear axle mounting screws and nuts.
5. Separate the rear axle case from brake case.
(When reassembling)
• Apply liquid gasket (Three Bond 1208D or equivalent) to joint
face of the rear axle case and brake case.
• Be sure to check and adjust the parking brake lever free play (see
page 5-S4).
W10200480
Tightening
torque
Rear axle case
mounting
screw and nut
M10 screw
48.1 to 55.9 N·m
4.9 to 5.7 kgf·m
35.4 to 41.2 ft-lbs
M10 nut (9T)
(Except
L3130, L3430)
60.8 to 70.5 N·m
6.2 to 7.2 kgf·m
44.9 to 52.1 ft-lbs
M12 screw
(Except
L3130, L3430)
77.5 to 90.2 N·m
7.9 to 9.2 kgf·m
57.1 to 66.5 ft-lbs
Stud bolt
24.5 to 31.4 N·m
2.5 to 3.2 kgf·m
18.1 to 23.1 ft-lbs
To Next Page
