Operation Multi 3430
30
ba75865e08 06/2010
4.2.5 Example 2 on navigation: Setting the date and time
The measuring instrument has a clock with a date function. The date
and time are indicated in the status line of the measured value display.
When storing measured values and calibrating, the current date and
time are automatically stored as well.
The correct setting of the date and time and date format is important for
the following functions and displays:
z Current date and time
z Calibration date
z Identification of stored measured values.
Therefore, check the time at regular intervals.
Note
After a fall of the supply voltage (empty batteries), the date and time are
reset to 01.08.2009 00, 00:00 hours.
Setting the date, time
and date format
The date format can be switched from the display of day, month, year
(dd.mm.yy) to the display of month, day, year (mm/dd/yy or mm.dd.yy).
8 Select the required language with <S><T>.
9 Confirm the setting with <MENU/ENTER>.
The meter switches to the measuring mode.
The selected language is active.
1 In the measured value display:
Open the Storage & config menu with <MENU/ENTER
_>.
The instrument is in the setting mode.
2 Select and confirm the System / Clock function menu with
<S><T> and <MENU/ENTER>.
The setting menu for the date and time opens up.
To Next Page
Loading...
Need help?
General
