Raw TCP/IP Printing
Raw TCP/IP is used to open a TCP socket-level connection over Port 9100, and stream a print-ready
file to the printer input buffer. It then closes the connection either after sensing an End Of Job
character in the PDL or after expiration of a preset timeout value. Port 9100 does not require an LPR
request from the computer or the use of an LPD running on the printer. Raw TCP/IP printing is
selected in Windows as the Standard TCP/IP port.
CCoonnffiigguurriinngg RRaaww TTCCPP//IIPP SSeettttiinnggss
1. In Xerox
®
CentreWare
®
Internet Services, click Properties→Connectivity→Protocols.
2. Click Raw TCP/IP Printing.
3. For Protocol, select Enable.
4. Ensure that Port Number is set to 9100.
5. Click Apply.
EEnnaabblliinngg RRaaww TTCCPP//IIPP PPrriinnttiinngg aatt tthhee PPrriinntteerr CCoonnttrrooll PPaanneell
1. At the printer control panel, press the Machine Status button.
2. Touch Network Settings→Advanced Settings.
3. Touch Raw TCP/IP-Printing.
4. Touch Enable.
5. Ensure that Port Number is set to 9100.
6. Touch OK.
28
Xerox
®
B1025 Multifunction Printer
System Administrator Guide
Network Connectivity
To Next Page
Loading...
