108 5 Control Panel Settings
Setting Example: Changing the Sleep Mode Timer
In this example, we will set the Sleep Mode Timer for operations in common menus to 240
minutes.
1. Press the <Menu> button on the control
panel to display the menu screen.
2. Press the < > button until [Admin Menu] is
displayed.
Note
• If you went past the desired item, return to the item by
pressing the < > button.
3. Press the < > or <OK> button to select.
Move on to the next lower level.
Note
• If you pressed the < > or <OK> button on the wrong
item, return to the previous screen by pressing the
< > or the <Return> button.
• To start over from the beginning, press the <Menu>
button.
4. Press the < > button until [System
Settings] is displayed.
5. Press the < > or <OK> button to select.
Move on to the next lower level.
6. Press the < > button until [Sleep Mode
Timer] is displayed.
7. Press the < > or <OK> button to select.
The current set value is displayed.
8. Press the < > or < > button to display
[240 Minutes].
Note
• Holding down the < > or < > button scrolls through
the options in a circular fashion.
9. Press the <OK> button to confirm your
selection.
The value is accepted.
10. The setting is now complete.
Press the <Menu> button to return to the
[Ready to print] screen.
Menu
LanguageEmulation
Menu
Admin Menu
Admin Menu
Network/Port
Admin Menu
System Settings
System Settings
Alert Tone
System Settings
Sleep Mode Timer
Sleep Mode Timer
•
1 Minutes
Sleep Mode Timer
240 Minutes
Sleep Mode Timer
•
240 Minutes
Ready to print
K C M Y
To Next Page
Loading...
