300 A Appendix
Before using the XPS driver, be sure to check whether the XPS print feature of the printer
you are using is enabled. Unexpected paper output may occur when an XPS driver is used
on a printer that does not have an XPS feature.
XPS stands for XML Paper Specification.
TCP/IP (lpd) Note and Limitations
The following notes and limitations apply to TCP/IP (lpd).
Printer Settings
• Take care to configure IP address settings correctly. IP addresses are system settings.
Be sure to consult your network administrator before configuring IP address settings.
• In some network environments, sub network mask and gateway address settings also
must be configured. Consult your network administrator about the settings required for
your printer.
• If memory is insufficient when a port is enabled, the port is automatically disabled. If this
happens, disable unused ports, change memory allocation, or install additional memory.
• Configure the size of the [LPD Spool] receive buffer in accordance with the printer's
operating conditions. Receive cannot be performed if the size of the [LPD Spool] receive
buffer is smaller than the received data.
Configuring Settings
• Take care to configure IP address settings correctly. IP addresses are system settings.
Be sure to consult your network administrator before configuring IP address settings.
• Consult your NIS administrator whenever configuring network settings (IP address) on a
computer that is under NIS (Network Information Service).
To Next Page
Loading...
