5.2 Common Menus Setting 123
[EtherTalk Compat]
[Bonjour]
Network/Port
EtherTalk Compat
EtherTalk Compat
Port Status
EtherTalk Compat
PJL
Setting Description
Port Status Sets whether to enable or disable the EtherTalk port at printer start-up.
• [Enabled]
• [Disabled] (default)
Important
• If the printer runs out of memory when the port is enabled, the port is
sometimes automatically disabled. If this happens, either disable unused
ports, or change the memory allocation under [Allocate Memory].
PJL Sets whether to enable or disable PJL commands that are sent from the
computer.
PJL commands control print jobs, and are required to print jobs using the print
driver. Use of PJL commands allows you to specify the language emulation for
the next job while another language emulation is being processed by the
printer. *5 (See P. 171.)
• [Enabled] (default)
• [Disabled]
Network/Port
Bonjour
Bonjour
Port Status
Setting Description
Port Status Sets whether to enable or disable the Bonjour port at printer start-up.
• [Enabled]
• [Disabled] (default)
Note
• To use the Multicast DNS feature, set [Enabled]. To use Bonjour to print on
the detector printer, also enable the LPD port.
Important
• If the printer runs out of memory when the port is enabled, the port is
sometimes automatically disabled. If this happens, either disable unused
ports, or change the memory allocation under [Allocate Memory].
To Next Page
Loading...
