122 5 Control Panel Settings
PJL Sets whether to enable or disable PJL commands that are sent from the
computer.
PJL commands control print jobs, and are required to print jobs using the print
driver. Use of PJL commands allows you to specify the language emulation for
the next job while another language emulation is being processed by the
printer. *5 (See P. 171.)
• [Enabled] (default)
• [Disabled]
Access Control Sets whether to enable or disable access control when stopping or deleting a
print job, pausing the printer, or when canceling a pause.
• [Disabled] (default)
• [Enabled]
DNS Sets whether or not to use the name registered to the DNS (Domain Name
System) when identifying the printer.
• [Enabled] (default)
The DNS name is used.
• [Disabled]
The IP address is used.
Added Port
Number
Sets the additional port number from 1 to 65535. *2 (See P. 171.)
• [80] (default)
Note
• Set only unique port numbers. Note, however, that InternetServices/IPP/
SOAP/UPnP/WSD ports and Internet services that use HTTP protocol can
share the same port number.
Connect Time-Out Sets the time after which data reception is canceled if data is not received.
Specify the value from 0 to 65535 seconds in 1-second increments.
• [60 Seconds] (default)
TBCP Filter Sets whether to enable or disable the TBCP filter during processing of
PostScript data.
• [Disabled] (default)
• [Enabled]
Setting Description
To Next Page
Loading...
Need help?
General