118 5 Control Panel Settings
[NetWare]
Network/Port
NetWare
NetWare
Port Status
NetWare
TransportProtocol
NetWare
Print Mode
NetWare
PJL
NetWare
No. of searches
NetWare
TBCP Filter
Setting Description
Port Status Sets whether to enable or disable the NetWare port at printer start-up.
• [Enabled]
• [Disabled] (default)
Important
• If the printer runs out of memory when the port is enabled, the port is
sometimes automatically disabled. If this happens, either disable unused
ports, or change the memory allocation under [Allocate Memory].
TransportProtocol Sets the protocol of the transport layer used by NetWare. Either or both of IPX/
SPX and TCP/IP can be selected.
• [TCP/IP,IPX/SPX] (default)
•[TCP/IP]
• [IPX/SPX]
Note
• When using TCP/IP protocol, both the printer and client computers must
have IP addresses.
Print Mode Sets the method of processing data (language emulation).
• [Auto] (default)
After receiving data from a computer, the printer automatically detects its
language emulation and processes the data accordingly. *1 (See P. 171.)
• [PS] [ESCP] [HP-GL/2] [PCL] [TIFF] [KS] [KSSM] [KS5895]
After receiving data from a computer, the printer processes the data with the
selected print language.
• [HexDump]
Allows you to view data received from a computer by printing it in ASCII code
(hexadecimal format). *3 (See P. 171.)
Note
• [KS], [KSSM], and [KS5895] appear when the Korea Font ROM (optional) is
installed.
To Next Page
Loading...
