5.2 Common Menus Setting 117
PJL Sets whether to enable or disable PJL commands that are sent from the
computer.
PJL commands control print jobs, and are required to print jobs using the print
driver. Use of PJL commands allows you to specify the language emulation for
the next job while another language emulation is being processed by the
printer. *5 (See P. 171.)
• [Enabled] (default)
• [Disabled]
Connect Time-Out Sets the time after which data reception is canceled if data is not received.
Specify the value from 2 to 3600 seconds in 1-second increments. *2 (See
P. 171.)
• [16 Seconds] (default)
TBCP Filter Sets whether to enable or disable the TBCP filter during processing of
PostScript data.
• [Disabled] (default)
• [Enabled]
Port Number Sets the port number from 1 to 65535. *2 (See P. 171.)
• [515] (default)
Note
• Set only unique port numbers.
Maximum Sessions Set the maximum number of clients that can connect to the printer
simultaneously by LPD. Specify the value from 1 to 10.
• [5] (default)
Print Queue Sets the print data queue.
• [Data Process Order] (default)
The printer prints print data in the order that it is processed.
• [Job Submit Order]
The printer prints print data in the order that it is received.
Setting Description
To Next Page
Loading...
