5.2 Common Menus Setting 129
[WSD]
[SOAP]
Network/Port
WSD
WSD
Port Status
WSD
Port Number
Setting Description
Port Status Sets whether to enable or disable the WSD port at printer start-up.
• [Enabled] (default)
• [Disabled]
Important
• If the printer runs out of memory when the port is enabled, the port is
sometimes automatically disabled. If this happens, either disable unused
ports, or change the memory allocation under [Allocate Memory].
Port Number Sets the port number from 1 to 65535.
• [80] (default)
Note
• Set only unique port numbers. Note, however, that InternetServices/IPP/
SOAP/UPnP/WSD ports and Internet services that use HTTP protocol can
share the same port number.
Network/Port
SOAP
SOAP
Port Status
SOAP
Port Number
Setting Description
Port Status Sets whether to enable or disable the SOAP port at printer start-up.
• [Enabled] (default)
• [Disabled]
Important
• If the printer runs out of memory when the port is enabled, the port is
sometimes automatically disabled. If this happens, either disable unused
ports, or change the memory allocation under [Allocate Memory].
Port Number Sets the port number from 1 to 65535.
• [80] (default)
Note
• Set only unique port numbers. Note, however, that InternetServices/IPP/
SOAP/UPnP/WSD ports and Internet services that use HTTP protocol can
share the same port number.