5.2 Common Menus Setting 149
User Detail Setup
StoreUser
Details
Sets whether to store authentication information to non-volatile memory
([NVM]) or the hard disk.
• [NVM] (default)
• [Hard Disk]
Note
• Appears when Network Accounting settings are configured.
Failed
Access Log
Sets whether or not to record failed authentication to [Error History
Report] when authentication fails for the preset number of times in 10
minutes. This is to detect invalid accesses.
•[Off]
• [On] (default)
When [On] is specified, the number of authentication failures
recorded can be specified as a value from 1 to 600.
Note
• Authentication failures are only recorded in [Error History Report],
and access denials, as in “[Panel Settings]” (P. 138) are not
recorded.
Save
Remote
Account
Sets whether or not to save remote accounts.
• [Disabled] (default)
•[Enabled]
Note
• This setting is displayed when the hard disk (option) is installed and
[Remote Accounts] is selected for [Login Type].
Charge Print Sets charge printing that uses authenticated user information.
PJL
Receive
Command
Reception of remote printing commands can be controlled by PJL
commands. When [Off] is set or no PJL command has arrived on the
printer, the [Receive Control] setting described later is used.
• [Off] (default)
•[On]
Note
• This feature is displayed only when the hard disk (option) is installed.
PJL
Output
Command
Printing of remote print jobs can be controlled by PJL commands.
• [Off] (default)
•[On]
Note
• This feature is displayed only when the hard disk (option) is installed.
Setting Description
To Next Page
Loading...
Need help?
General