5.2 Common Menus Setting 157
[PaperTrayPriority]
Setting Description
Plain, Recycled,
Bond, Plain S2,
1. Custom 1 to
5. Custom 5
This setting will be used by the Auto Tray Selection feature. Defaults are as
follows: Plain=[1], Recycled=[2], Plain S2=[Not Selected], Bond=[3].
Otherwise, the default is [Not Selected].
• [1] to [15]
Sets the priority order of paper types.
• [Not Selected]
Does not set the priority order of paper types. In this case, the Auto Tray
Selection feature is not used.
Note
• [1. Custom 1] to [5. Custom 5] display the names specified under [Custom
Paper Name].
• You can assign the same priority order to different paper types. In this case,
the printer selects a tray based on the [Paper Tray Priority] setting.
Printer Settings
PaperTrayPriority
PaperTrayPriority
1
PaperTrayPriority
2
PaperTrayPriority
3
Setting Description
1 to 3 Sets the priority order of the paper trays. This setting will be used by the Auto
Tray Selection feature. You cannot assign a priority order to the bypass tray.
• [Tray 1] to [Tray 4]
Sets the priority order of the paper trays. By default, the priority order of the
trays is: Tray 1, Tray 2, Tray 3, and Tray 4.
Note
• You cannot assign the same priority to more than one tray. Tray [2] must be a
tray other than Tray [1], and Tray [3] must be a tray other than Trays [1] and
[2]. The remaining tray will be Tray [4].
• This item appears only when the optional trays are installed.
To Next Page
Loading...
