7.12 Cleaning the Printer 265
2. Rotate the lever on the front left side to
unlock it.
3. Open the drum cartridge cover.
4. Pull the cleaning rod from the lower right
corner of the drum cartridge slot.
5. Pull out the cleaning rod until it stops, and
then move it all the way in and out two or
three times to clean the LED scanner.
Repeat this step for all four drum
cartridges.
Important
• Make sure you pull the cleaning rods out as far as they
will go. Also push them in as far as they will go.
• Do not use excessive force when pulling the cleaning
rods.
6. Close the drum cartridge cover.
To Next Page
Loading...
Need help?
General