7.9 Adjusting Color Density 199
12. After entering the values, press the <Eject/
Set> button to confirm your entry.
13. When adjusting the density of other colors,
return to Step 9 by pressing the < > button
and repeat the same steps.
14. When you are finished with the settings,
press the <Menu> button to return to the
print screen.
After changing the density settings for all colors, reprint the Calibration Chart using the
procedure in "Printing the Calibration Chart" (P. 195).
If the result is not satisfactory, perform the calibration again.
[Process Gray] is gray made by mixing CMY toners. If the calibration was a success, the
process gray should be close to black.
If either one of colors in CMY is stronger than the other two, perform calibration again for
that color.
Cyan
L= 0,M= 0,H=-2*
To Next Page
Loading...
