Xerox Phaser 6100

U SING P APER OR S PECIALTY
2.3
2
Guidelines for Paper and Specialty Media
When selecting or loading paper, envelopes, or other specialty
media keep these guidelines in mind:
• Attempting to print on damp, curled, wrinkled, or torn paper
can cause paper jams and poor print quality.
• Use cut-sheet paper only. You cannot use multi-part paper.
• When printing transparencies, use only Phaser 35-Series
Premium Transparency Film.
• Do not use paper with irregularities, such as tabs or staples.
• Do not attempt to load any tray while printing and never
overfill the tray. This could cause a paper jam.
• Avoid paper with embossed lettering, perforations, or a
texture that is too smooth or too rough.
• Colored paper should be of the same high quality as white
photocopy paper. The pigments must withstand the printer’s
fusing temperature of 180°C (356°F) for 0.1 seconds without
deteriorating. Do not use paper with a colored coating that
was added after the paper was produced.
• Preprinted forms must be printed with nonflammable, heat-
resistant ink that does not melt, vaporize, or release
hazardous emissions when subject to the printer’s fusing
temperature.
• Store paper in its ream wrapper until you are ready to use it.
Place cartons on pallets or shelves, not on the floor.
• Do not place heavy objects on top of the paper, whether it is
packaged or unpackaged.
• Keep paper away from moisture, direct sunlight or other
conditions that can cause it to wrinkle or curl.
NOTE : Do not use carbonless paper and tracing paper. The
chemicals can damage your printer.