Troubleshooting
WorkCentre 5300 Series Multifunction Printer
User Guide
190
5. Check inside the finisher for any loose staples and remove them.
6. Open the staple cartridge clamp by pulling firmly in the direction shown.
WARNING: The points of the jammed staples are sharp. Remove the jammed staples carefully.
7. Remove the jammed staples (1), then push the clamp in the direction shown until it snaps into the
locked position (2).
8. Grip the staple cartridge by the orange handle and insert it into the stapler until it clicks into place.
9. Close the finisher front door.
wc53xx-098
1
2
To Next Page
Loading...
