Xerox WorkCentre 5325 User Manual

Printing
WorkCentre 5300 Series Multifunction Printer
User Guide
58
3. Stack the paper against the left rear corner of the tray as shown.
Note: Do not load paper above the maximum fill line. Doing so may cause paper jams.
4. Adjust the guides so that they touch the edges of the stack.
5. Close the tray
6. Verify the size, type, and color of the paper. Change the selection for any incorrect Setting.
7. On the printer touch screen, touch Confirm.
Configuring Tray 6
Tray 6 is a dedicated high-capacity feeder. It must be configured to support the paper in use. If the tray
has never been used, it must be configured for the desired paper size. If you are changing the paper
size, you must reconfigure the tray for the new paper size.
Before changing the drawer configuration, always compare the paper size to the Tray 6 configuration.
If the paper size matches, no adjustment is needed.
wc53xx-120

Xerox WorkCentre 5325 Specifications

General

Print Technology	Laser
Functions	Print, Copy, Scan, Fax
Print Speed (Black)	Up to 25 ppm
Print Resolution	Up to 1200 x 1200 dpi
Standard Paper Capacity	1, 090 sheets
Max Paper Capacity	5, 090 sheets
Processor	533 MHz
Copy Speed	Up to 25 cpm
Copy Resolution	Up to 600 x 600 dpi
Scan Resolution	Up to 600 x 600 dpi
Duplex Printing	Automatic
Paper Sizes	A4, A5
Memory	256 MB
Hard Drive	80 GB
Connectivity	USB 2.0, Ethernet
Scan Destinations	Email, Network, USB
Fax Transmission Speed	33.6 Kbps
Operating System Compatibility	Windows, macOS, Linux