4. Safe Driving
102
Dynamic Parking BrakeDynamic Parking Brake
─
If a sudden emergency such as braking failure occurs during
driving, lift the EPB switch to turn on the dynamic parking
brake. Then the vehicle will decelerate at a certain speed
until it is braked to the stationary state or the EPB switch is
released.
►
The dashboard will display "Dynamic Braking".
Caution
●
When ESP fails, the dynamic parking brake is applied
using the EPB. As the EPB only acts on the rear wheels, it
is recommended not to use the dynamic parking brake
in non-emergency situations, otherwise it can easily
cause an accident and shorten the life of the EPB.
AutoHold
When you need to park your vehicle temporarily, press the brake
pedal deeply after the vehicle stops, and the instrument panel
indicator is on. At this time, you do not need to continue
pressing the brake pedal as the AutoHold will be activated for
you to keep the vehicle stopped. When you press the accelerator
pedal and start driving, AutoHold will automatically disable.
─
Tap "Vehicle Control
→
Vehicle Settings
→
Driving
→
AutoHold" on the CID to activate/deactivate AutoHold.
Note
●
To trigger AutoHold, the driver door must be closed,
the seat belt is fastened and gear is in D, R or N.
Warning
●
AutoHold cannot exceed the laws of kinematics, so
please enable the parking brake according to the
road conditions.
To Next Page
Loading...
