4. Safe Driving
1
2
3
4
5
6
7
8
9
10
11
93
Seat Belts with Collision Warning
Seat belts have the following functions:
1. Gap elimination: when the vehicle is ready and the driver
has fastened the seat belt, or when the driver returns to
normal sitting position after leaning forward too much,
the seat belt will automatically retract, eliminate the gap
between the driver and seat belt strap for better restraint
protection.
2. Auto retraction: when the driver unlocks the seat belt
buckle, the seat belt will retract smoothly until it is fully
retrieved.
3. Level 2 collision pre-warning: When the seat belt receives
an FCM warning signal during driving, the seat belt will
vibrate to alert the driver.
4. Level 3 collision pre-tensioning: when the seat belt
receives an FCW collision pre-tensioning signal during
driving, the seat belt will retract automatically, restraining
the driver on the backrest and reducing the risk of injury
or death.
Note
●
In order to ensure that the electric seat belt works
reliably, there is a limit to the number of times each
function of the electric seat belt can be used. When
the number of times for one function is triggered
reaches the upper limit, the corresponding function
will no longer be triggered, but other functions will
not be aected. Please contact your local authorized
service center for replacement in time.
Warning
●
Do not modify or repair the seat belt by yourself,
please have it inspected or repaired at your local
authorized service center.
●
In a collision or similar situation, the seat belts shall
be promptly replaced after being subjected to a
strong impact. Replacement is also a must if a seat
belt has any sign of wear or damage.
●
Although seat belts can alert you of a hazard, or
avoid or mitigate injury to you in the event of danger,
you still need to drive carefully to avoid the hazard.
To Next Page
Loading...
Need help?
General
