6. XPILOT Driving
1
2
3
4
5
6
7
8
9
10
11
145
Active Lane Change (ALC)*
ALC is a comfortable driving assist feature based on Lance
Centering Control (LCC). On unobstructed highways or urban
expressways, this feature can assist the driver to change lanes
as instructed.
ALC is suitable for unobstructed highways and dry roads with
clear lane lines, and shall be disabled on city streets.
Turning On/O with CIDTurning On/O with CID
─
After the vehicle is Ready, the ALC switch defaults to
the last operating state. After shifting the gear to P, tap
“Vehicle Control
→
XPILOT
→
Active Lane Change” to turn
on/o ALC.
How to Use ALC:How to Use ALC:
After LCC is activated and the steering wheel icon turns blue
at the right side of the dashboard, when the driving speed
is 65–120 km/h with the Blind Spot Security switch on, ALC is
available. At this time, follow the steps below to use ALC:
1. Confirm the driving environment is safe and suitable for a
lane change;
2. Turn on the corresponding turning light after lane
changing safety is confirmed;
3. When ALC intelligently assists the driver to change lanes,
always keep an eye on the lanes and take over the vehicle
in time when necessary.
4. Turn off the turning light after changing lanes. At this
point, LCC continues to assist the driver in keeping the
vehicle in the center of the lane.
ALC cannot assist the driver to make lane changes
continuously, but only one lane change at one time. To change
lanes again, repeat the above steps.
To Next Page
Loading...
Need help?
General
