4. Safe Driving
94
Checking the Seat BeltsChecking the Seat Belts
To confirm that each seat belt is functioning properly, the
following three simple inspection items shall be conducted:
1. Check the seat belt, buckle and other devices for damage,
modification, bleach, stain or dirts.
2. Fasten the seat belt and pull it out quickly at the closest
point to the buckle. The buckle shall remain securely
locked.
3. Unbuckle the seat belt and retract it to the greatest extent.
Check the seat belt for excessive looseness and wear.
4. Pull out the seat belt halfway. Hold the latch and pull
the belt forward quickly. The internal locking mechanism
of the seat belt will lock automatically to prevent over-
unreeling of the belt.
If any seat belt fails any of the above test, please contact your
local authorized service center immediately.
Adjusting the Shoulder Belt HeightAdjusting the Shoulder Belt Height
─
Up: adjust the shoulder harness to the proper height by
holding the guide and moving it upward.
─
Down: press and hold the guide unlock switch and move
down to adjust the shoulder harness to the proper height.
─
After adjustment, check if the guide is securely locked.
To Next Page
Loading...
Need help?
General
