Yamaha FT50C - Assembling the Drive Shaft; Installing the Pinion; Installing the Lower Unit

62Y5A11
6-22
1
2
3
4
5
6
7
8
9
2. Install the new needle bearing into the
forward gear to the specified depth.
Assembling the drive shaft
1. Install the new drive shaft bearing into
the drive shaft using a press.
NOTE:
Use the special service tool or a general pipe
with the specified measurements.
Installing the pinion
1. Install the forward gear, then the drive
shaft assembly, pinion, and pinion nut,
and then tighten the nut to the specified
torque.
Installing the lower unit
1. Set the gearshift to the neutral position at
the lower unit.
Bearing inner race attachment
1
:
90890-06662
Needle bearing attachment
2
:
90890-06614
Driver rod L3
3
: 90890-06652
Depth
a
: 1.1 mm (0.04 in)
Bearing inner race attachment
1
:
90890-06643
Drive shaft holder 4
1
: 90890-06518
Pinion nut holder
2
: 90890-06505
Socket adapter 2
3
: 90890-06507
T
R
.
.
Pinion nut:
95 N·m (9.5 kgf·m, 68 ft·lb)
S62Y6850K
Drive shaft and lower case