62Y5A11
7-38
1
2
3
4
5
6
7
8
9
9. Install the relief valve bracket
H
by
installing the bolts
I
, then tightening
them to the specified torque.
10. Install the filters
J
and gear pump
K
by
installing the bolts
L
, then tightening
them to the specified torque.
11. Install the manual valve
M
and reservoir
cap
N
.
12. Fill the reservoir with the recommended
fluid to the correct level as shown.
13. Install the joint
O
and power trim and tilt
motor
P
by installing the bolts
Q
, then
tightening them to the specified torque.
Assembling the trim cylinder
1. Install the dust seal
1
into the tilt cylinder
end screw
2
.
T
R
.
.
Relief valve bracket bolt
I
:
5.3 N·m (0.53 kgf·m, 3.8 ft·lb)
Gear pump bolt
L
:
6.5 N·m (0.65 kgf·m, 4.7 ft·lb)
Recommended power trim and tilt
fluid:
ATF Dexron
II
To Next Page
Loading...
