Yamaha RTX810 - Page 132

132
Operating and managing the product
7
Operating the product using
a firmware in an external
memory device
You can operate the product using a rmware stored in
a commercially-available external memory device (USB
memory stick or microSD card). This is convenient when
you want to store a rmware for emergency or trial use in
an external device and use it only on an as-needed basis,
without upgrading the rmware in the product.
Change settings so that the product
can be started by using a firmware file
in an external device
In the “Startup via external memory” eld on the “Congure
external device” screen, select “allow”.
To open the “Configure external device” screen
From “Basic conguration page”, click the buttons on the
setup screen in the following order:
▶ “Advanced settings” in the top page
▶ “Congure” of “Congure external device”
Start the product using a firmware in
an external memory device
1
Prepare an external memory device containing
firmware.
Specify the same le name as that specied in the
“Firmware le name” eld on the “Congure external
device” screen.
2
Insert the external device into the USB port
or microSD slot of the product.
The USB lamp or microSD lamp of the product lights
up or ashes.
3
Restart the product.
After the restart, the product automatically loads the
rmware specied in step 1.
Tip
The rmware stored in the product is not overwritten.
Note
If loading the rmware le from the external device fails, see
“Unable to use USB device” (page 152).
Using the latest function (Revision up)
(Continued from the previous page)