Yamaha RTX810 - Page 136

136
Operating and managing the product
7
4
To stop saving the log, select “terminate” in the
“Save Syslog” field on the “Configure external
device” screen, and click “Submit”.
5
Hold down the USB button or microSD button
for two seconds.
The USB lamp or microSD lamp of the product goes
off.
6
Remove the external memory device.
Note
• The log is not recorded immediately after the start, immediately
after inserting a USB memory stick, and right before removing
the USB memory stick.
• The log cannot be written to the USB memory stick until it
is ready to be written.
• If saving of the log to the external device fails, see “Unable
to use USB device” (page 152).
Notes on the log to be saved
When you start saving the log, the following log les are
generated in the USB memory stick or microSD card.
• A le to which the log is currently written: The le name
is the same as that specied in the “Save administration
information” eld on the “Congure external device”
screen.
• A backup le generated for each certain size: The le
name is generated by adding saved date/time to the above
le name.
Restriction of backup file
If the number of backup les has reached the dened upper
limit, or the memory in the external memory device is full,
the oldest backup le is deleted.
Note
If the external memory device does not have sufcient free
space, the dened log le size or number of backup les
may be different from that actually generated.
Checking the configuration information and log of the
product
(Continued from the previous page)