Yamaha RTX810 - Page 91

91
Implementing site-to-site VPN connections
4
1
Enter necessary setup information.
Configuration name
Enter a descriptive destination name.
Destination IP address
Enter the IP address assigned to the connection
destination.
Connection provider
Specify the congurations used for a closed network
connection (congurations you set on page 89).
Note
When separately conguring the PPPoE connection for
Internet access, you should exercise care not to incorrectly
specify the connection setting for Internet access.
Configure routing information
Enter the network address of the destination LAN
in “route address information” and “route net mask
information”.
2
Click “Submit”.
The “Register VPN connection setting” screen appears.
3
To connect the product to multiple LANs, click
“Back” and repeatedly configure “Configure
routing information”.
Congure the routing information for each connection
destination.
Note
Correctly set a combination of the IP addresses assigned
to connection destinations and network address of its
destination LAN.
After you have set all routing information for the
connection destinations, click “Return to top” to return
to the top page of the “Basic conguration page”.
Creating IPIP tunnel
connections
Once the above congurations have been completed, IPIP
tunnel communications are automatically established (no
manual operations are required). Once the IPIP tunnel
connections are complete, the top page of the “Basic
conguration page” shows a message, “Communicating”.