YASKAWA DX200 - Page 98

Description of Units and Circuit Boards
8 - 98
STROKE CHANGE1
SINGLE SOLENOID
DOUBLE SOLENOID
This is a signal, when a double stroke gun is used, to change the open
stroke of the welding gun.
GUN PRESS COMMAND
This outputs gun press command.
1. This signal can be set as “USE” or “NOT USE” by pseudo input signal ”8202x”. If “NOT USE” is selected, this
signal can be used as the universal I/O signal described in parentheses.
2. This signal can be select “USE” or “NOT USE” by pseudo input signal "8202x". If "NOT USE" is selected, this
signal can be used as the universal I/O signal described in parentheses.
3. This signal can be allocated to any universal I/O signal at the I/O allocation display in operation condition.
Timer cooling water error validating (
or IN09)
Low air pressure validating (or IN12)
GUN Cooling Water Error Validating
(or IN10)
Weld ON/OFF Validating (or OUT09)
Transthermo error validating (or
IN11)
Pseudo Input Signal 8202x
Logical num-
ber
Input name / Function
7 6 5 4 3 2 1 0
0 0 0 1 1 1 1 1
3
1
2
4
5
6
1
4
2
5
3
6