Electrical Installation
5
5.4 Control Circuit Wiring
YASKAWA TOEPYAIGA5002A GA500 Programming 509
Figure 5.5 Locations of Switches
Table 5.8 I/O Terminals and Switches Functions
Position Switch Terminal Function Default
A Jumper switch S5 AM Sets the output method for terminal AM (voltage or current). V (voltage output)
B
DIP switch S1 A2 Sets the input method for terminal A2 (voltage or current). I (current input)
DIP switch S2 -
Enables and disables the MEMOBUS/Modbus communications termination
resistor.
OFF
To Next Page
Loading...
