User Constants
10-37
10
* 15.If the setting is 0, the axis will accelerate to the specified speed for the specified acceleration time (C1-01 to C1-08).
* 16.Applicable for G7-Series Inverters with software versions PRG: 1038 and later.
* 17.Applicable for G7-Series Inverters with software versions RPG: 1034 or later.
* 18.Applicable for G7-Series Inverters with software versions PRG:1039 or later.
* 19.If a current exceeding 110% of the Inverter rated current flows through the unit, the carrier frequency will automatically decrease and electromagnetic noise will
occur.
To Next Page
Loading...
