Customizing Your Phone
23
Activating the Wi-Fi Mode
Procedure
1. Navigate to Menu->Settings->Basic Settings->Wi-Fi.
2. Tap Switch to select On from the Wi-Fi field.
3. Tap Save.
The IP phone scans the available wireless networks in your area.
Deactivating the Wi-Fi Mode
You should deactivate the Wi-Fi mode when you need to connect your phone to the wired network.
Procedure
1. Navigate to Menu->Settings->Basic Settings->Wi-Fi.
2. Tap Switch to select Off from the Wi-Fi field.
3. Tap Save.
Connecting to the Wireless Network
There are three ways to connect IP phones to the wireless network:
l Connecting to an Available Wireless Network Manually
l Connecting to the Wireless Network Using Wi-Fi Protected Setup (WPS)
l Adding a Wireless Network Manually
Connecting to an Available Wireless Network Manually
Before You Begin
Get the password of the wireless network from your system administrator. Make sure that the Wi-Fi mode is activated.
Procedure
1. Navigate to Menu->Settings->Basic Settings->Wi-Fi.
2. Highlight the X Available Network(s) (X represents the number of available networks), and then tap Enter.
3. (Optional.) To research the available network, tap Scan.
4. Select the desired wireless network and then tap Connect.
5. If the network is secure, enter its password.
6. Tap OK.
Related Topic
Activating the Wi-Fi Mode
Connecting to the Wireless Network Using Wi-Fi Protected Setup (WPS)
Wi-Fi Protected Setup (WPS) provides simplified mechanisms to configure secure wireless networks which can auto-
matically configure a wireless network with a network name (SSID) and strong WPA data encryption and authen-
tication.
There are two methods supported by Yealink IP phones in the Wi-Fi protected setup:
To Next Page
Loading...
