Yealink CP920 User Guide
66
Related Topics
Adjusting the Audio Volume
Pausing/Resuming a Playback
When you receive an incoming call while playing a recording, the recording is paused automatically. You can resume
the playback after handling the call. You can also pause the recording manually at any time.
Procedure
1. Tap Pause to pause the playback. The Play soft key appears on the phone screen.
2. Tap Play.
Fast Forwarding/Rewinding a Playback
While a recorded call plays, you can fast forward or rewind the playback at any time.
Procedure
l Tap to skip forward the playback. Press once to skip forward 8 seconds.
l Tap to rewind the playback. Press once to rewind 8 seconds.
Stopping a Playback
When you finish listening to a recording, you can stop playing by tapping the Back soft key. The phone returns to the
Browse Audio screen.
Deleting a Recorded Call
You can delete the recorded calls when you need additional space on your USB flash drive.
Procedure
1. Navigate to Menu->USB->Browse Audio.
2. Highlight the desired recording, and then tap Delete.
The phone screen prompts you whether to delete the audio.
3. Tap OK to delete.
Multicast Paging
Multicast Paging allows you to easily and quickly broadcast instant audio announcements to users who are listening to
a specific multicast group on a specific channel.
The IP phone supports the following 31 channels:
l 0: Broadcasts are sent to channel 0. Note that the Yealink IP phones running old firmware version (old paging mech-
anism) can be regarded as listening to channel 0. It is the default channel.
l 1 to 25: Broadcasts are sent to channel 1 to 25. We recommend that you specify these channels when broadcasting
with Polycom IP phones which have 25 channels you can listen to.
l 26 to 30: Broadcasts are sent to channel 26 to 30. We recommend that you specify these channels when broad-
casting with Yealink IP phones running new firmware version (new paging mechanism).
Note that all IP phones in the multicast paging group must be deployed in the same network, since a broadcast is used.
The IP phone can only send/receive broadcasts to/from the listened channels. Other channels’ broadcasts will be
ignored automatically by the IP phone.
To Next Page
Loading...
