Yealink CP920 - Retrieving a Parked Call in the FAC Mode; Parking or Retrieving a Call in the Transfer Mode; Parking a Call in the Transfer Mode; Retrieving a Parked Call in the Transfer Mode

Yealink CP920 User Guide
74
l If you want to park the call against the local extension, tap the # key.
l If you want to park the call against the desired extension, enter the extension (for example, 4606) where you
want to park the call and tap the # key.
If the call is parked successfully, you will hear a voice prompt that the call is parked.
Retrieving a Parked Call in the FAC Mode
Before You Begin
Your system administrator has set call park in the FAC mode. There is a call parked on the extension.
Procedure
1. Tap Retrieve (You may need to tap the More soft key to see the Retrieve soft key) on the pre-dialing screen.
The phone will dial the park retrieve code which is configured in advance.
2. Follow the voice prompt to retrieve:
l Tap the # key on the phone where the call is parked.
l Enter the desired extension followed by # (for example, 4606#) on any phone.
Parking or Retrieving a Call in the Transfer Mode
Your system administrator has set the Transfer mode in which you can park and retrieve a call on your phone.
Topics
Parking a Call in the Transfer Mode
Retrieving a Parked Call in the Transfer Mode
Parking a Call in the Transfer Mode
Before You Begin
Your system administrator has set call park in the Transfer mode.
Procedure
1. During a call, tap Park (You may need to tap the More soft key to see the Park soft key).
The call will be directly transferred to the shared parking lot.
Retrieving a Parked Call in the Transfer Mode
Before You Begin
Your system administrator has set call park in the Transfer mode. There is a call parked on the shared parking lot.
Procedure
1. Tap Retrieve (You may need to tap the More soft key to see the Retrieve soft key) on the pre-dialing screen.
The phone will retrieve the parked call from the shared parking lot.
Shared Line
Yealink IP phone supports using Shared Call Appearance (SCA) or Bridged Line Appearance (BLA) to share a line. So
that this line can be registered on more than one IP phone at the same time.
Your system administrator can set your phone to use the shared line.