Yealink VC110 - Page 118

Administrator’s Guide for Yealink VC110 Video Conferencing Endpoint
102
Parameter
Description
Configuration Method
Note: If you change this parameter,
the endpoint will reboot to make the
change take effect.
Video Priority
Specifies the DSCP value for video
packets.
Valid Values: 0-63
Default: 34
Note: If you change this parameter,
the endpoint will reboot to make the
change take effect.
Remote Control
Web User Interface
Data Priority
Specifies the DSCP value for data
packets.
Valid Values: 0-63
Default: 63
Note: If you change this parameter,
the endpoint will reboot to make the
change take effect.
Remote Control
Web User Interface
To configure QoS via web user interface:
1. Click on Network->Advanced.
2. In the QoS block, enter the desired values in the corresponding fields.
3. Click Confirm to accept the change.
A dialog box pops up to prompt that the settings will take effect after a reboot.