Yealink VC110 - Configuring SIP Settings; SIP Account

Administrator’s Guide for Yealink VC110 Video Conferencing Endpoint
134
For more information on how to use refer to VC110 Video Conferencing Endpoint User Guide .
Configuring SIP Settings
Yealink VC110 video conferencing endpoint support Session Initiation Protocol (SIP). If your
server supports SIP, you can use SIP to establish calls.
SIP Account
To establish calls using SIP, you can configure a SIP account for the endpoint.
SIP account parameters on the endpoint are described below:
Parameter
Description
Configuration Method
SIP Account
Enables or disables the SIP account.
Default: Enabled
Remote Control
Web User Interface
Register Name
Configures the user name of the SIP
account for register authentication.
Default: Blank
Remote Control
Web User Interface
User Name
Specifies the user name to use for
authentication when registering with
a SIP server.
Default: Blank
Remote Control
Web User Interface
Password
Specifies the password associated
with the user name used to
authenticate the endpoint to the SIP
server.
Default: Blank
Remote Control
Web User Interface
Server/Server
Host
Configures the IP address or domain
name of the SIP server for the SIP
account.
Default: Blank
Remote Control
Web User Interface
SIP Server
Port/Port
Configures the port of the SIP server.
Valid values: Integer from 0 to
65535.
Default: 5060
Remote Control
Web User Interface
Outbound/Enable
Outbound Proxy
Server
Enables or disables the endpoint to
send requests of the SIP account to
the outbound proxy server.
Remote Control
Web User Interface