Yealink VC110 - Site Name

Configuring Endpoint Settings
173
2. Select desired value from the pull-down list of Remote Control Enabled.
3. Click Confirm to accept the change.
Site Name
When the endpoint is idle, the site name is displayed on the status bar of display device and
video conferencing phone. You can make an IP address call to the far site, the site name will be
displayed on the display device of the far site. Site name can consist of letters, numbers or
special characters. You can configure the site name of the endpoint via the remote control or
web user interface.
The site name parameter is described below:
Parameter
Description
Configuration Method
Site Name
Configures the site name of the
endpoint.
Valid values: String within 64
characters
Default: Yealink VC110
Remote Control
Web User Interface
To configure the site name via web user interface:
1. Click on Setting->General.