Administrator’s Guide for Yealink VC110 Video Conferencing Endpoint
210
To configure camera settings via the remote control:
1. Select Menu->Video & Audio->Camera General Settings.
2. Configure the camera settings.
3. Press the Save soft key to accept the change.
Multiple Preset
You can store the preset to a numeric key via the remote control or web user interface. Each
camera preset stores the camera pan, tilt, and zoom settings. This means that you can point a
camera at pre-defined locations by pressing stored keys.
You can store up to 10 preset camera positions using the remote control. If you want to store
more than 10 preset camera positions, you can enable the multiple preset feature. So that you
can store up to 64 preset camera positions for your camera.
The following example illustrates a scenario where multiple preset feature is used:
There are multiple speakers in a large meeting room. You can set multiple preset camera
positions for each speaker. When someone speaks, the camera can be adjusted to the
corresponding preset camera position that is associated with the current speaker.
Multiple preset parameters are described below.
Enables or disables the multiple preset
feature on the endpoint.
Default: Off
Points local camera at a preset position
Moves local camera to a preset position.
Deletes the selected preset position.
Clears all preset positions.
Remote Control
Web User Interface
To configure multiple preset via web user interface:
1. Click on Setting->Camera.
To Next Page
Loading...
