Yealink VC110 - Page 159

Configuring Call Preferences
143
Parameter
Description
Configuration Method
Gatekeeper IP Address
1/Gatekeeper Server 1
Configures the IP address of the
primary H.460 server.
Note: It is configurable only when
the Gatekeeper Mode is set to
Manual.
Remote Control
Web User Interface
Gatekeeper Port
1/Port
Configures the port of the primary
H.460 server.
Valid values: Integer from 0 to
65535.
Default: 1719
Remote Control
Web User Interface
Gatekeeper IP Address
2/Gatekeeper Server 2
Configures the IP address of the
secondary H.460 server.
Note: It is configurable only when
the Gatekeeper Mode is set to
Manual.
Remote Control
Web User Interface
Gatekeeper Port
2/Port
Configures the port of the
secondary H.460 server.
Valid values: Integer from 0 to
65535.
Default: 1719
Remote Control
Web User Interface
H.460 Active
Enables or disables firewall
traversal of H.323 calls using H.460
protocols.
Default: Disabled
Remote Control
Web User Interface
To enable H.460, configure the H.323 preferences first, as described in Configuring H.323
Settings chapter with the following exceptions:
To configure H.460 firewall traversal for H.323 via web user interface:
1. Click on Account->H.323.
2. Select Manual from the pull-down list of Gatekeeper Mode.
3. Enter the IP address and port number of the H.460 server in Gatekeeper IP Address and
Port fields.