Yealink VC110 - Page 215

Configuring Endpoint Settings
199
The MTU parameter on the endpoint is described below.
Parameter
Description
Configuration Method
Video MTU
Specifies the maximum MTU size (in
bytes) of video packets sent by the
endpoint.
Valid Values: Integer from 1000 to
1500
Default: 1500
Note: If you change this parameter,
the endpoint will reboot to make the
change take effect.
Remote Control
Web User Interface
To configure MTU via web user interface:
1. Click on Network->Advanced.
2. In the MTU block, enter the desired value in the Video MTU field.
3. Click Confirm to accept the change.
A dialog box pops up to prompt that the settings will take effect after a reboot.
4. Click Confirm to reboot the endpoint immediately.
To configure MTU via the remote control:
1. Select Menu->Advanced (default password: 0000) ->Advanced Network.
2. Enter the desired value in the Video MTU(1000-1500) field.