Yealink VC110 - Page 223

Configuring Endpoint Settings
207
Parameter
Description
Configuration Method
room.
 Cool Daylight
 Neutral Daylight
 Florescent
 Incandescent
 Manual—Manually set red and
blue gain.
Default: Auto
Red Gain
Configures the red gain of the
camera.
Valid Values: 0-100
Default: 0
Note: You can set this parameter
only when the white balance mode
is configured to Manual.
Remote Control
Web User Interface
Blue Gain
Configures the blue gain of the
camera.
Valid Values: 0-100
Default: 0
Note: You can set this parameter
only when the white balance mode
is configured to Manual.
Remote Control
Web User Interface
Saturation
Configures the saturation of the
camera.
Valid Values: 0-14
Default: 7
Remote Control
Web User Interface
Sharpness
Configures the sharpness of the
camera.
Valid Values: 0-14
Default: 5
Note: The picture will be sharp and
clear, but moderate to heavy motion
at low call rates can cause some
frames to be dropped.
Remote Control
Web User Interface
Brightness
Configures the brightness of the
camera.
Remote Control
Web User Interface