Yealink VC110 - Page 232

Administrator’s Guide for Yealink VC110 Video Conferencing Endpoint
216
sites, the two sites must enable FECC (SIP) protocol simultaneously to perform far-end camera
control. If FECC (SIP) protocol and FECC (H.323) protocol are both enabled, the endpoint will
select the appropriate camera control protocol according to the protocol (SIP or H.323) the call
uses.
Camera control protocol parameters are described below:
Parameter
Description
Configuration Method
FECC(H.323)
Enables or disables the FECC (H.323)
protocol for far site to control near
camera. You can configure it for the
StarLeaf Cloud platform or H.323 call
separately.
Default: Enabled
Web User Interface
FECC(SIP)
Enables or disables the FECC (SIP) protocol
for far site to control near camera. You can
configure it for the
Zoom/Pexip/BlueJeans/Mind/Custom
platform, SIP account or SIP IP call
separately.
Default:
For Zoom/Pexip/BlueJeans/Mind/Custom
platform and SIP IP call, the default value
is Enabled.
For SIP account, the default value is
Disabled.
Note: You cannot configure it for the
Yealink/StarLeaf Cloud platform.
Web User Interface
To configure FECC(H.323) camera control protocol for StarLeaf Cloud platform via web
user interface:
1. Click on Account->VC Platform.
2. Select StarLeaf from the pull-down list of Platform Type.