Yealink VC110 - Page 292

Administrator’s Guide for Yealink VC110 Video Conferencing Endpoint
276
MIB
OID
Description
Format:
MacVersion[*]ComVersion[*]
For example,
MacVersion[0.0.0.1]ComVersion[0.0.0.1]
YEALINK-MIB
1.3.6.1.2.1.37459.2.1.1
1.0
The command of the endpoint reboot.
Format:
snmpset -v 2c XXXX public 37459.2.1.11.0 s
reboot
XXXX refers to the IP address of the endpoint.
SNMP parameters on the endpoint are described below:
Parameter
Description
Configuration Method
SNMP->Active
Enables or disables SNMP feature on
the endpoint.
Default: Disabled
Note: If you change this parameter,
the endpoint will reboot to make the
change take effect.
Web User Interface
Port
Specifies the SNMP port.
Valid Values: 1-65535
Default: 161
Note: If you change this parameter,
the endpoint will reboot to make the
change take effect.
Web User Interface
Trusted Address
Configures IP address(es) or domain
name of the trusted SNMP server.
Multiple IP addresses or domain
names should be separated by
spaces.
Note: If it is left blank, the endpoint
accepts and handles GET requests
from any SNMP server.
If you change this parameter, the
endpoint will reboot to make the
change take effect.
Web User Interface
To configure SNMP via web user interface:
1. Click on Network->Advanced.