Administrator’s Guide for Yealink VC110 Video Conferencing Endpoint
58
server via DHCP option 12. Host
name is optional, so it is not a
mandatory configuration item. For
more information, contact your
network administrator.
If you change this parameter, the
endpoint will reboot to make the
change take effect.
To configure DHCP via web user interface:
1. Click on Network->LAN Configuration.
2. In the IPv4 Config block, mark the DHCP radio box.
3. (Optional.) Enter the host name of the endpoint in the Host Name field.
4. Click Confirm to accept the change.
A dialog box pops up to prompt that settings will take effect after a reboot.
5. Click Confirm to reboot the endpoint immediately.
To Next Page
Loading...
