Yealink VC110 - Far-end Camera Control

Administrator’s Guide for Yealink VC110 Video Conferencing Endpoint
66
Parameter
Description
Configuration Method
Default: Blank
Note: If you change this parameter,
the endpoint will reboot to make the
change take effect.
IPv6
prefix((0~128)
Configures the IPv6 prefix.
Default: Blank
Note: If you change this parameter,
the endpoint will reboot to make the
change take effect.
Remote Control
Web User Interface
Gateway
Configures the IPv6 default gateway.
Default: Blank
Note: If you change this parameter,
the endpoint will reboot to make the
change take effect.
Remote Control
Web User Interface
Static DNS/Static
IPv6 DNS
Triggers the static IPv6 DNS feature
to on or off.
Default: Off
Note: If you change this parameter,
the endpoint will reboot to make the
change take effect.
Remote Control
Web User Interface
DNS Primary
Server/Primary
DNS
Configures the primary IPv6 DNS
server.
Default: Blank
Note: If you change this parameter,
the endpoint will reboot to make the
change take effect.
Remote Control
Web User Interface
DNS Secondary
Server/Secondary
DNS
Configures the secondary IPv6 DNS
server.
Default: Blank
Note: If you change this parameter,
the endpoint will reboot to make the
change take effect.
Remote Control
Web User Interface
To configure IPv6 address assignment method via web user interface:
1. Click on Network->LAN Configuration.
2. Select the desired IP mode (IPv6 or IPv4 & IPv6) from the pull-down list of IPv4/IPv6.
3. In the IPv6 Config block, mark the DHCP or the Static IP radio box.