Yealink VC110 - Page 92

Administrator’s Guide for Yealink VC110 Video Conferencing Endpoint
76
Parameters of VLAN feature on the endpoint are described below.
Parameter
Description
Configuration Method
DHCP
VLAN->Active
Enables or disables the DHCP VLAN
discovery feature on the endpoint.
Default: Enabled
Note: If you change this parameter,
the endpoint will reboot to make the
change take effect.
Web User Interface
Option
Configures the DHCP option from
which the endpoint obtains the
VLAN settings.
You can configure at most five
DHCP options and separate them by
commas.
Valid Values: 128-254
Default: 132
Note: If you change this parameter,
the endpoint will reboot to make the
change take effect.
Web User Interface
To configure DHCP VLAN discovery via web user interface:
1. Click on Network->Advanced.
2. In the VLAN block, select the desired value from the pull-down list of DHCP VLAN Active.
3. Enter the desired option in the Option field.