Yealink VC110 - Ending Calls

Configuring Network
79
To configure 802.1X via web user interface:
1. Click on Network->Advanced.
2. In the 802.1x block, select the desired protocol from the pull-down list of Mode 802.1x.
a) If you select EAP-MD5:
1) Enter the user name for authentication in the Identity field.
2) Enter the password for authentication in the MD5 Password field.
b) If you select EAP-TLS:
1) Enter the user name for authentication in the Identity field.
2) Leave the MD5 Password field blank.
3) In the CA Certificates field, click Browse to locate the desired CA certificate
(*.pem,*.crt, *.cer or *.der) from your local endpoint.
4) In the Device Certificates field, click Browse to locate the desired client
certificate (*.pem or *.cer) from your local endpoint.