Yealink VC110 - Page 139

Configuring Endpoint Settings
129
Many countries have used DST at various times, details vary by location. DST can be
adjusted automatically from the time zone configuration. Typically, there is no need to
change this setting.
DST parameters are described below:
Parameter
Description
Configuration
Method
DHCP Time
Enables or disables the
endpoint to update time with
the offset time obtained from
the DHCP server.
Default: Disabled
Note: it is only available to
GMT 0.
Web User Interface
Time Zone
Configures the time zone.
Default: +8 China (Beijing)
Remote Control
Web User Interface
Primary Server/NTP Primary
Server
Configures the primary NTP
server.
Default: cn.pool.ntp.org
Remote Control
Web User Interface
Secondary Server/NTP
Secondary Server
Configures the secondary NTP
server.
Default: cn.pool.ntp.org
Remote Control
Web User Interface
Synchronism
(15~86400s)
Configures the interval (in
minutes) for the endpoint to
synchronize time and date
with NTP server.
Default: 1000.
Web User Interface
Daylight Saving
Time
Configures the Daylight
Saving Time (DST) type.
The available types for the
endpoint are:
 Disabled-not use DST.
 Enabled-use DST.
You can manually
configure the start time,
end time and offset
according to your needs.
 Automatic-use DST.
DST will be configured
Remote Control
Web User Interface