VC110 Video Conferencing Endpoint Introduction
15
To remove the VCM60 from the VC110 video conferencing endpoint, do the following:
1. Remove the dongle from the VC110 all-in-one unit.
The display device prompts ―Dongle remove!‖. And the icon disappears from
the status bar.
The VCM60 supports two standby modes: online standby and offline standby.
Online standby:
When registering with dongle successfully, the VCM60 enters online standby mode
and the mute indicator LED changes to green and is in breathing state.
Offline standby:
If VC110 video conferencing endpoint encounters poor signal, wireless interference
or is powered off, the VCM60 may lose connection with the dongle. In this case, the
VCM60 will search the dongle again, and the mute indicator LED fast flashes green.
If dongle cannot be searched in 2 minutes, the VCM60 will enter offline standby
mode automatically and the mute indicator LED slowly flashes orange.
When the VCM60 is in offline standby mode, you need to tap the mute button to
activate VCM60 to search dongle again and the mute indicator LED fast flashes
green.
To Next Page
Loading...
